San Luis Obispo, CA (May 20, 2009) - The Synergy Suspension Double Adjuster Tube Adapter is the perfect solution to fine tune steering and suspension link geometry without removing any components. Not only does it save time, but the secure pinch-bolt design eliminates pesky traditional jam nuts that always come loose.

“Simply loosen the Pinch Bolt, twist the Adjuster Sleeve, and then tighten the Pinch Bolt, and your done!”

The Double Adjuster Tube Adapter is ideal for steering and link suspension designs with weld-on bushings/joints at one end. Bent link applications are also ideal, as the double adjuster tube adapter provides precise adjustment without twisting the link out of position. Common applications are: custom tie-rods, control arms, drag links, track bars, trailing arms, and 3 or 4-link suspensions.

The weld-on Tube Adapter is manufactured of solid 1018 steel and when installed, it seals the tube from water and debris preventing corrosion damage from within the tube.

Poly Performance Double Adjuster Tube Adapters are available in 5 sizes, 7/8″-14 for 1″ ID tube, 7/8″-18 for 1″ ID tube, 1″-14 for 1 1/4″ ID tube, 1 1/4″ for 1 3/8″ ID tube, and 1 1/4″ for 1 1/2″ ID tube. Each set is sold with one Weld-on Tube Adapter, one Zinc plated Double Adjuster Sleeve and 1/2″ Pinch Bolt hardware. A retail price of $50.00 is suggested.

For more information about Synergy Suspension Double Adjuster Tube Adapters, visit www.synergysuspension.com (keywords “Synergy Suspension Double Adjuster Tube Adapter“) or call 1-805-242-0397. Dealer inquiries welcome.

Synergy Suspension Double Adjuster Tube Adapter

• The Synergy Suspension Double Adjuster Tube Adapter is designed to eliminate the need for jam nuts that are normally used when building link suspension & steering systems.
• The use of the Double Adjuster allows the suspension/steering link to be adjusted without removal.
• The Double Adjuster allows the user to fine-tune the suspension/steering geometry  by loosening the pinch bolt and turning the adjuster sleeve.
• Ideal for link suspension designs with weld on bushings/joints at one end or bent suspension links.
• The weld on tube adapter is made from solid stock 1018 Steel.
• The tube adapter seals the link off from water or other debris entering the link which can cause damage over time.
• An integrated drain hole lets any water that enters the threads of the adapter drain out.

Adapters Include:

• (1) Weld on Tube Adapter with Pinch Bolt Slit and Tubes
• (1) Zinc Plated Double Adjuster Sleeve to be used with 1 1/4″ LH Thread Shank Rod End
• (1) 1/2″ Pinch Bolt Hardware
• All Adjusters Use A Left Hand Threaded Rod End or Johnny Joint

www.synergysuspension.com